VT

Flow Measurement
Differential pressure Flowmeters
Wafer-Cone® Flowmeters

Wafer-Cone® differential pressure fl owmeter and one from a variety of differential pressure transmitters are integrated into one flowmeter.
It can measure mass flow rate of liquids, gases with pressure and temperature compensation, and saturated steam.
It also serves in the hazardous area of chemical plants.
You can make use of existing transmitters by combining them to the models without transmitters.

Catalogs and Brochures

*Specifications are subject to change without prior notice.

Features

  • Simple installation
    Wafer connection makes installation simple. Flowmeter body flanges are designed to match the pipe flanges by guiding the flowmeter in the center line by fastening bolts.
  • Short straight runs
    The required straight runs are less than 1/5 of those required for orifi ce and vortex flowmeters.
    The narrow installation space allows simple and flexible piping arrangement plan.
    It leads to space and cost saving.
  • Low pressure loss
    A proper selection of ß ratio allows lower pressure loss than orifi ce plate with the same flow rate. It improves energy efficiency of the plant.
  • 3-way stopcock installed
    By operating its handle a newly developed 3-way stopcock can switch isolation, equalizing or measuring mode.
    This stopcock prevents mechanically such wrong operations as running off seal liquid in the impulse piping and overpressurizing to the one side of differential transmitter which might occur with the traditional three way manifold.
  • Wide variety of transmitters
    Explosionproof type, pressure and temperature compensation type, and other types are available.
    You can make use of your transmitters also.

Specifications

Measuring medium Liquids, Gases, Saturated steam
Nominal diameter 25 to 100 (mm)
1, 1-1/2, 2, 2-1/2, 3, 4 (inch)
Flow Range
Water: 
Max. 0 to 119.73 m³/h (100A, at 20°C)
Min. 0 to 5.51 m³/h (25A, at 20°C)
Air: 
ax. 0 to 10385 m³/h(nor) (100A, at 0°C,0.99MPa)
Min. 0 to 77m³/h(nor) (25A, at 0°C,0MPa)
Saturated steam: 
Max. 0 to 10745 kg/h (100A, at1.6MPA)
Min. 0 to 103 kg/h (25A, at0.1MPA)
Fluid Temperature Liquids: -20°C to 120°C
Gases: -20°C to 120°C
Saturated steam: Max.204.3 °C
Fluid Pressure Liquids: -98kPa to 2MPa
Gases: -98kPa to 1MPa
Saturated steam: -98kPa to 1.6MPa
Process Connection JIS10K/20K, ANSI Class150/300, DIN PN16/40, GB PN1.6/4.0
Accuracy ±1.0 to 1.5 %(F.S.)

Contact usProduct Inquiry

We will answer your product inquiries and technical questions.